Skip header
 

Connecting to the Ethernet Interface

This section describes how to connect an Ethernet interface cable to the Ethernet port.

Important

  • If the main power switch is on, turn it off.

  • Use the Unshielded Twisted Pair Cable (UTP) or Shielded Twisted Pair Cable (STP) and Category type 5 or more.

1Make sure the main power is switched off.

2Connect the Ethernet interface cable to the Ethernet port.

illustration of connecting Ethernet cable

3Connect the other end of the Ethernet interface cable to a network connection device such as a hub.

4Turn on the main power switch of the machine.

Ethernet port illustration (numbered callout illustration)

  1. Indicator (yellow)

    When 100BASE-TX is operating, the LED is lit yellow.

  2. Indicator (green)

    When 10BASE-T is operating, the LED is lit green.

Note

  • For details about how to turn on the main power switch, see "Turning On the Main Power", Getting Started.

  • For details about installing the printer driver, see "Installing the Printer Driver", Driver Installation Guide.

PreviousNext