Previous
Use this function to scan the front and back side of two-sided originals page by page.
You must place originals into the ADF and use Memory Transmission when using this function.
This function is available for SP 3610SF only.
How to specify the orientation and page opening orientation settings
To transmit the original so that its front and back sides can be printed in the same orientation, configure the "Original Orientation" and "Page Opening Orientation" settings according to the orientation of the original to be placed.
Unless the "Original Orientation" and "Page Opening Orientation" settings are configured properly, the orientation of the front and back sides of the original may be in reverse when printed at the destination.
Original |
Original position |
Original Orientation |
Page Opening Orientation |
|---|---|---|---|
|
|
|
Top to Top |
|
|
|
Top to Bottom |
|
|
|
Top to Top |
|
|
|
Top to Bottom |
Select the setting items using the [
] or [
] key.
Place the original in the ADF, and then select the scan settings you require
Press [TX Mode]
Select [2 Sided TX] 
Press [OK]
Select [2 Sided from 1st Page] Press [OK]
If you want to cancel two-sided transmission, select [Off].
Select the original orientation Press [OK]
Select the page opening orientation Press [OK]
Press [Escape]
Specify a destination Press [Start]
For details about acceptable original size and paper thickness for two-sided scanning with the ADF, see "Recommended Original Sizes and Weights", Paper Specifications and Adding Paper.
