You can set conditions when using PostScript for printing.
Job Timeout
You can specify how long the printer waits (in seconds) before canceling the current job when the job is interrupted while being processed. If you select [Use Machine Setting(s)], enter a value between 0 to 999. (Default: 0)
Default: [Use Driver/Command]
Use Driver/Command
Use Machine Setting(s)
Wait Timeout
You can specify how long the printer waits (in seconds) before it denies receiving a job when the printer cannot determine when the job ends. If you select [Use Machine Setting(s)], enter a value between 0 to 999. (Default: 300)
Default: [Use Driver/Command]
Use Driver/Command
Use Machine Setting(s)
Duplex
You can specify whether or not to print on both sides of a sheet. If you specify duplex printing, you must also specify the binding method.
Default: [Off]
Off
Long Edge Bind
Short Edge Bind
Blank Page Print
You can specify whether or not to print blank pages.
Default: [On]
On
Off
Data Format
You can select the data format from Binary Data or TBCP.
When binary data is sent from the printer driver when the printer is working with a USB connection, the print job is canceled.
Default: [Binary Data]
Binary Data
TBCP
When an Ethernet connection is used, the print job is canceled if:
The printer driver data format is TBCP and the data format selected using the control panel is Binary Data.
The printer driver data format is binary and the data format selected using the control panel is TBCP.
Resolution
You can specify the resolution.
Default: [600dpi]
600 dpi
1200dpi