This describes the parameters that can be set on [Administrator Tools].
Service Test Call
You can make a test call to the @Remote center. This function is available only if the @Remote service is enabled and active. This function is unavailable when [Notify Machine Status] or [Remote Diagnostics] is in use.
Notify Machine Status
You can send notification of the printer's status to the @Remote center. This function is available only if the @Remote service is enabled and active. This function is unavailable when [Service Test Call] or [Remote Diagnostics] is in use.
Remote Diagnostics
You can send a request to repair the printer to the service center. This function is available only if the @Remote service is enabled and active. This function is unavailable when [Service Test Call] or [Notify Machine Status] is in use.
Firmware Version
You can display the firmware version of the printer.
Fixed USB Port
Specifies whether the same printer driver can be used for multiple printers or not under USB connection.
Default: [Off]
On
The same printer driver you have installed in your computer can be used with any printer other than the one originally used for installation, if the printer is of the same model.
Off
You must install the printer driver separately for individual printers, because the printer other than the original will be recognized as a new device upon USB connection.
Reset All Settings
You can reset the printer settings to their factory defaults. Be sure to turn off and then on the main power of the printer to make the setting effective.
Reset All Settings
You can reset all printer settings to their factory defaults.
Reset Network Settings
You can reset the network settings of the printer to their factory defaults.
Time Zone
You can specify the time zone by entering the time difference between your local time zone and Coordinated Universal Time (UTC). You can enter a value between -1440 and +1440 minutes.
User Restriction
You can specify whether or not to restrict the control panel operation by setting a password. Even if this feature is enabled, it is not necessary to enter the password when printing from a computer or clearing errors.
For details, see Security Guide.
Default: [Off]
On
Off
Slp Tmr after Engy Sv Prt
When [Ready State After Printing] is set to [Cntrl Panel Off (EngySavg)], you can specify whether or not the printer resumes Sleep mode immediately after exiting Energy Saver mode.
Default: [Immediate]
Immediate
The printer resumes Sleep mode immediately after printing, regardless of the Sleep Mode Timer settings.
After Time Set by Tmr Ends
The printer resumes Sleep mode after the time specified in Sleep mode elapses.
Ready State After Printing
You can specify how the printer operates when it receives print jobs in Sleep mode.
Default: [Cntrl Panel Off (EngySavg)]
Control Panel On
The printer turns on the control panel and prints received jobs.
Cntrl Panel Off (EngySavg)
The printer prints received jobs but the control panel remains off.