Previous
This section describes the parameters that can be set on [Interface Settings].
Network
Machine IPv4 Address
You can specify the printer's IPv4 network address.
Default: [Auto-Obtain (DHCP)]
When you select [Specify], enter the IPv4 address and subnet mask as "xxx.xxx.xxx.xxx" ("x" indicates a number).
When you select [Specify], make sure that the IPv4 address is different from that of other printers on the network.
The physical address (MAC address) also appears.
IPv4 Gateway Address
You can specify the gateway address for the router or host computer used as a gateway.
A gateway is a connection or interchange point between two networks.
Default: [0.0.0.0]
Machine IPv6 Address
You can specify the printer's IPv6 network address.
Link-local Address
The printer's specified link-local address appears.
Manual Config. Address
The printer's manually configured address appears. You can specify the printer's IPv6 address manually.
Prefix Length
You can specify the IPv6 Prefix Length.
Default:[64]
Stateful Address
The printer's specified stateful address appears.
Stateless Address: 1-3
The specified stateless address appears if [IPv6 Statlss Addr Autocnfg] is set to [Active].
DHCPv6
You can specify the DHCPv6 setting.
Default: [Inactive]
DHCPv6
DHCPv6-lite
Inactive
IPv6 Statlss Addr Autocnfg
You can specify IPv6 Stateless Address Autoconfiguration.
Default: [Active]
IPv6 Gateway Address
You can specify the printer's IPv6 gateway address.
DNS Configuration
You can configure settings for the DNS server. When you select [Specify (IPv4)] or [Specify (IPv6)], select [Server 1] or [Server 2], and then enter the DNS Server IP address as "xxx.xxx.xxx.xxx" ("x" indicates a number).
Specify (IPv4)
Server 1
Server 2
Specify (IPv6)
Server 1
Server 2
DNS Protocol Priority
You can specify the priority protocol to be registered to the DNS server.
Default: [IPv4]
IPv4
IPv6
IPsec
This is a security function. For details, see Security Guide.
Default: [Inactive]
Active
Inactive
Domain Name
You can specify the domain name. When you select [Specify], enter the domain name using up to 63 characters.
Default: [Auto-Obtain (DHCP)]
Effective Protocol
You can specify the effective protocol.
IPv4
Default: [Active]
Active
Inactive
IPv6
Default: [Inactive]
Active
Inactive
HTTP (IPv4)
Default: [Active]
Active
Inactive
HTTP (IPv6)
Default: [Active]
Active
Inactive
Web
Default: [Active]
Active
Inactive
Ethernet Speed
You can specify the network speed to operate the printer. If a communication error occurs because of compatibility problems with the hub, select a speed suitable for your network environment.
Default: [Auto Select]
Auto Select
100Mbps Full Duplex
100Mbps Half Duplex
10Mbps Full Duplex
10Mbps Half Duplex
Host Name
You can specify the host name. Enter the host name using up to 31 characters.
The following host names are unacceptable:
A host name starting with or ending with a hyphen
A host name in which hyphens are used consecutively
A host name starting with a dot
A host name in which dots are used consecutively
A host name starting with "RNP" or "rnp"
Machine Name
You can specify the printer name. Enter the printer name using up to 31 characters.
USB Speed
You can specify the USB speed.
Default: [Auto Select]
Auto Select
Full Speed
Print I/F Settings List
You can print the printer's current network settings and network information.
For details about how to configure the settings using Web Image Monitor, see Web Image Monitor Help.
