Status Messages

“Energy Saver Mode”

The printer is in Energy Saver mode. Press any key to recover to the normal mode.

“Hex Dump Mode”

In Hex Dump mode, the printer receives data in a hexadecimal format. Turn off the printer after printing, and then turn it on again.

“Job Suspended”

All jobs are suspended. Turn off the printer, and turn it on again to resume the jobs.

“Offline”

The printer is offline and cannot print.

“Please wait...”

This message may appear for a few seconds. It means the printer is initializing, replenishing toner, or performing maintenance operations. Wait a while.

“Printing...”

The printer is printing. Wait a while.

“Printing Suspended”

Printing is suspended. To resume printing, press the [Suspend/Resume] key.

“Ready”

This is the default ready message. The printer is ready for use. No action is required.

“Resetting Job”

The printer is resetting the print job. Wait a while.

“Setting change...”

The printer is applying the changes made to its settings. Wait a while.

“Updating Certificate...”

The printer is updating the @Remote certificate. Turn the power off, and then turn it on again.

“Waiting for print data...”

The printer is waiting for the next data to print. Wait a while.

“Hex Dump Mode”

In Hex Dump mode, the printer receives data in a hexadecimal format. Press [Job Reset] to cancel Hex Dump mode.

“Job suspended.”

Printing was temporarily suspended because [Job Operation] or the [Suspended] key was pressed.

“Loading Toner...”

The printer is loading the toner. Wait a while.

“Offline”

The printer is offline.

“Please wait.”

This message might appear for a second or two while the printer is preparing, performing initial adjustments, or adding toner. Wait a while.

“Printing...”

The printer is printing. Wait a while.

“Ready”

This is the default ready message. The printer is ready for use. No action is required.

“Resetting job...”

The printer is resetting the print job. Wait until “Ready” appears on the display panel.

“Setting change...”

The printer is changing settings. You cannot use the control panel while this message is displayed. Wait a while.

“Suspended job exists.”

Printing was temporarily stopped by SmartDeviceMonitor for Client.

You can resume printing via [My Job List] in SmartDeviceMonitor for Client, or via the Web Image Monitor. To resume printing via Web Image Monitor, ask your system administrator first.

“Updating certif...”

The @Remote certificate is being updated. Wait a while.

“Waitg. for prt.data”

The printer is waiting for the next data to print. Wait a while.