Previous
Follow the procedure below to set the printer to receive an IP address automatically using DHCP. The DHCP feature is active by default, so this procedure is only required if you have changed the default settings.
When [Auto-Obtain (DHCP)] is selected, you cannot configure the IP address, subnet mask, or gateway address.
Press the [Menu] key, and then select the setting items using the [
] or [
] key.
Select [Host Interface] 
Press [OK]
Select [Network] Press [OK]
Select [Machine IPv4 Address] Press [OK]
Select [Auto-Obtain (DHCP)] Press [OK]
You can check the detected addresses by pressing [IP Add.], [Subnet M], and [Gateway].
Press the [User Tools] key, and then display the [Network] screen.
[System Settings] |
Enable IPv4 protocol, and then specify the IPv4 address.
|
