Adjusting the Print Position
PreviousNext
You can adjust the printing position. Normally you do not need to update the printing position. However, updating is useful in some cases.
You can adjust the printing position for the following trays:
Horizontal and vertical positions for Trays 1 to 3 and bypass tray
Horizontal and vertical positions for the back side of the paper during duplex printing
Press the [User Tools/Counter] key.
Press [
], and then press [Maintenance].
Press [Adjust Print Position].
Press [Print Test Sheet] next to the tray which you want to adjust.
For the bypass tray, you cannot print the test sheet. Proceed to step 6.
Print the test sheet to preview the settings.
Use this sheet to confirm the current print position.
Select the tray you want to adjust.
Change the registered value (mm) using the number keys.
Increase the value to shift the print area in the direction indicated by the "+" symbol in the diagram below. Decrease to shift the print area in the direction indicated by the "-" symbol.
: Print Area
: Paper Feed Direction
Press [OK].
If you want to adjust the back side, Press [].
Press [Print Test Sheet] next to [Back Side].
Print the test sheet to preview the settings.
Use this sheet to confirm the current print position.
Press [Back Side].
Use the same procedure as step 7 to change the registered value (mm) using the number keys.
Press [OK].
Press [Exit].
Press the [User Tools/Counter] key.
