Previous
If [Auto-Download] is enabled in [Download Setting], and an updated firmware version is available, the firmware is automatically downloaded when the machine is in Ready mode. This reduces the amount of time required for updates.
An auto-download is only performed while the contact list screen is being displayed.
After the auto-download is complete, a message appears when you turn off the machine. The message indicates the machine is ready to update the firmware. Check the details of the update, and then update the firmware as needed.
Auto-downloads are not performed during a meeting, while a screen other than the contact list screen is being displayed, or while the machine is off.
If [Auto-Download] is enabled, auto-downloads will be performed. A certain amount of packet communication might occur if a download is performed while the contact list screen is being displayed, even though a meeting is not being held. In addition, a network channel might also be used.
If an attempt is made to update firmware which was not fully downloaded, the download will be resumed and completed before the start of installation.
In the Features screen, press the [
] or [
] key to select [Configuration Menu], and then press the [Enter] key/
.
Press the [
] or [
] key to select [Firmware Update], and then press the [Enter] key/.
Press the [] or [] key to select [Download Setting], and then press the [Enter] key/.
Press the [] or [] key to select [Enabled] or [Disabled], and then press the [Enter] key/.
Press the [] or [] key to select [OK], and then press the [Enter] key/.
Press the [] or [] key to select [Close], and then press the [Enter] key/.
