If the machine will not be used for a long time, turn its power off, disconnect the USB cable, and then unplug it from the wall outlet. It is recommended to print at least once a month, because the machine consumes a considerable amount of ink for periodic maintenance and print head cleaning when turned on after a long period of inactivity.
|
|
Be careful of the following:
The nozzles of the print heads may dry out and become clogged. To prevent this, periodically print something. Even if you do not print anything, turn the machine on for a few minutes once every 20-25 days.
If you do not use the machine for a long period of time, always check if the nozzles are clogged by printing a nozzle check test pattern. See Nozzle Check Pattern. Clean the print heads as necessary, and then begin printing. See Clean Print-heads.
If you try to use the machine after it has been out of use for a long time, it may not print properly even if head cleaning is carried out several times. If this is the case, carry out head flushing. See Flush Print-heads. If the print heads are still clogged, leave the machine for about ten minutes, and then print the nozzle check pattern. If the problem persists, turn the machine off and leave it for at least eight hours. This should unclog the print heads.
After head cleaning is performed multiple times, clogged ink will dissolve over time, and normal printing may become possible.
If there is no improvement after performing the steps above, contact sales or service representative.