User parameters allow you to customize various settings to suit your needs. To change function settings, set the user parameter switches.
Switches and Bits
Each Parameters setting has a set of switches, and each of the switches consist of eight bits, whose values are "0" or "1". The right most bit is bit 0 and the left most is bit 7. You can adjust the settings to match your needs by switching the value of bits between "0" and "1".
Switch 00:
1 |
1 |
1 |
1 |
1 |
0 |
1 |
1 |
7 |
6 |
5 |
4 |
3 |
2 |
1 |
0 |
Parameter Settings List
Parameter settings are outlined below.
Switch |
Bit |
Function |
0 |
1 |
---|---|---|---|---|
00 |
7 |
Detect the dial tone when called |
Call without the detection |
Call after the detection* |
6 |
Detect the dial tone when called (Before calling PSTN call number). |
Call without the detection |
Call after the detection* |
|
5 |
Detect the dial tone when called (After calling PSTN call number). |
Call without the detection |
Call after the detection* |
|
4 |
Detect the busy tone when transmitted. |
Do not detect (process the Fax communication) |
Detect (disconnect the line if line is busy.)* |
|
01 |
4 |
Input Address Twice |
Do not Use* |
Use |
* This is a factory default.