Skip header
Help
 

Attaching and Detaching the Paper Feed Unit

This section explains how to attach and detach the paper feed unit.

CAUTION


  • The machine weighs around 15.3 kg (33.8 lb.).

  • Grip the center area at the base of the machine's sides. Lift it slowly and do not strain your body.

  • When moving the machine, remove the option. Careless handling and over exertion when lifting can result in breakage and/or injury.

Important

  • Before installing or removing options, always disconnect the power cord plugs from the wall outlet.

Attaching the paper feed unit

1Press and hold down the [Power] key until it turns off, and then unplug the power cord.

2Disconnect all the cable.

3Take the paper feed unit out of the box, and remove the tape.

4Position the paper feed unit close to the machine.

5Align the connecting parts of the machine and paper feed unit, and then lower the machine onto the paper feed unit.

paper feed unit illustration

Grip the center area at the base of the machine's sides. Lift it slowly and do not strain your body.

6Connect the power cord and other required cables.

Note

  • Align the paper feed unit and machine using their corners.

  • When the machine is placed on top of the paper feed unit, installation is complete.

  • Do not tilt the machine.

  • Make sure not to trap your fingers.

  • Up to two paper feed units can be attached.

  • To install two paper feed units, put the upper paper feed unit (tray 2) on the lower paper feed tray (tray 3) first, and then lower the machine onto the upper paper feed unit (tray 2).

  • After attaching an option, check that the printer driver has recognized it. See Specifying Settings on [Accessories] Tab, Displaying the Machine Status on a Macintosh.

  • After attaching the paper feed unit, you must register where to start printing on paper loaded in the paper feed unit. See Registration.

Detaching the paper feed unit

1Press and hold down the [Power] key until it turns off, and then unplug the power cord.

2Disconnect all the cable.

3Remove the machine and place it on a nearby flat and stable surface, and then detach the paper feed unit from the place where the machine was installed.

paper feed unit illustration

Grip the center area at the base of the machine's sides. Lift it slowly and do not strain your body.

4Place the machine in the previous place.

5Connect the power cord and other required cables.

Note

  • Do not tilt the machine.

  • Make sure not to trap your fingers.