Skip header
 

Loading Paper into the Wide Large Capacity Tray

Important

  • Check that the paper edges are aligned with the left side.

1Check that paper in the paper tray is not being used, and then pull the tray carefully out until it stops.

Wide LCT illustration

2Load paper into the paper tray with print side up.

Do not stack paper over the limit mark.

Wide LCT illustration

3Carefully push the paper tray fully in.

Note

  • If you select Thick Paper 2 to 4, [Coated Paper], [Label Paper], or [OHP (Transparency)] in [Tray Paper Settings], air is blown out automatically to fan the paper loaded in the wide LCT. Fan this paper before loading it. For details, see Fanning the Paper.

  • Various sizes of paper can be loaded in the wide LCT by adjusting the positions of side fences and end fence. For details, see Changing the Paper Size in the Wide Large Capacity Tray.

  • You can load envelopes in the wide LCT. When loading envelopes, place them in the correct orientation. For details, see Envelopes.

PreviousNext