Previous
Check that the paper edges are aligned with the left side.
Check that paper in the paper tray is not being used, and then pull the tray carefully out until it stops.
Remove paper if loaded.
Loosen the screws holding the side fences in position.
Take the grips of the side fences with your fingers, and then slide the side fences outward.
Grips
While pressing the release button of the end fence, slide the end fence outward.
Load paper into the paper tray with print side up.
Load a stack of paper about 5–10 mm (0.2–0.4 inches) high.
Make sure that the paper rest on top of the supporting plates on both sides.
Supporting plate
Take the grips of the side fences with your fingers, and adjust the side fences to the paper size.
Set the paper flush against the protrusions in the bottom of the inner side fence.
Check that the scale numbers on the top of the side fences are roughly the same.
Hold the inner side fence, and then tighten the screws to the inner side fence.
Fasten the front side fence in the same way.
Load additional sheets, if necessary.
Do not stack paper over the limit mark.
While pressing the release button of the end fence, align the end fence gently against the paper you loaded.
Make sure that there is no space between the paper and end fence.
Carefully slide the paper tray fully in.
After sliding the paper tray in, make sure that the paper size is changed correctly on the copier initial screen. To display the copier initial screen, press the [Home] key, and then press the [Copier] icon.
You can load envelopes into the wide LCT. When loading envelopes, place them in the correct orientation. For details, see Envelopes.
