Replacing Other Consumables

Refer to the maintenance guide provided with the new items for the replacement.

Do not incinerate toner (new or used) or toner containers. Doing so risks burns. Toner will ignite on contact with naked flame.

Do not store toner (new or used) or toner containers anywhere near naked flames. Doing so risks fire and burns. Toner will ignite on contact with naked flame.

Do not use a vacuum cleaner to remove spilled toner (including used toner). Absorbed toner may cause a fire or explosion due to electrical contact flickering inside the vacuum cleaner. However, it is possible to use a vacuum cleaner that is explosion-proof and dust ignition-proof. If toner is spilled on the floor, remove the spilled toner slowly using a wet cloth, so that the toner is not scattered.

Do not crush or squeeze toner containers. Doing so can cause toner spillage, possibly resulting in dirtying of skin, clothing, and floor, and accidental ingestion.

Store toner (new or used), toner containers, and components that have been in contact with toner out of reach of children.

If toner or used toner is inhaled, gargle with plenty of water and move into a fresh air environment. Consult a doctor if necessary.

If toner or used toner gets into your eyes, flush immediately with large amounts of water. Consult a doctor if necessary.

If toner or used toner is swallowed, dilute by drinking a large amount of water. Consult a doctor if necessary.

When removing jammed paper or replacing toner, avoid getting toner (new or used) on your clothing. If toner comes into contact with your clothing, wash the stained area with cold water. Hot water will set the toner into the fabric and make removing the stain impossible.

When removing jammed paper or replacing toner, avoid getting toner (new or used) on your skin. If toner comes into contact with your skin, wash the affected area thoroughly with soap and water.

The fusing unit becomes very hot. When installing a new fusing unit, turn off the printer and wait at least an hour after power off before replacing parts. Not allowing the printer to cool may result in burns.

Exposure to light reduces black drum unit/color drum units performance. Replace the unit as quickly as possible.
Do not pull out the black drum unit/color drum units quickly or with force as it may fall.
Take care that nothing comes into contact with the bottom surface of the black drum unit/color drum units.
When installing the drum unit, do not tilt, turn upside down, or shake it.
Waste toner bottles cannot be reused.
Purchasing and storing extra waste toner bottles is recommended.
Before removing the waste toner bottle from the printer, spread paper or some other material around the area to keep toner from dirtying your workspace.

Black Drum Unit/Color Drum Unit

Replace the drum unit when the following messages appear on the display:

“Replacmnt Requird:PCU:Black”

“Replace PCU: Black.”

“Replacmnt Requird:PCU:Color”

“Replace PCU: Color.”

When the following messages appear on the display, the drum unit should be replaced soon.

“Rplcmnt Rqrd Soon:PCU:Black”

“Rplcmnt Rqrd Soon:PCU:Color”

Waste toner bottle

Replace the waste toner bottle when the following message appears on the display:

“Waste Toner Bottle full”

When the following message appears on the display, the waste toner bottle should be replaced soon.

“Waste Toner almost full”

Fusing unit

Replace the fusing unit when the following messages appear on the display:

“Replacmnt Rqrd: Fusing Unit”

“Replace Fusing Unit.”

When the following message appears on the display, the fusing unit should be replaced soon.

“Repl Requrd Soon: FusingUnit”

Intermediate transfer unit

Replace the intermediate transfer unit when the following message appears on the display:

“Replacemnt Requird: IntTrans”

When the following message appears on the display, the intermediate transfer unit should be replaced soon.

“Replcmnt Rqrd Soon: IntTrans”