Previous
Orientation-fixed (top to bottom) or two-sided paper (for example, letterhead paper, punched paper, or copied paper) might not print correctly, depending on how the paper is placed.
Settings using the control panel
Specify [Auto Detect] or [On (Always)] for [Letterhead Setting] in [Machine Modes] under [Print Settings], and then place the paper as shown below.
For details about the letterhead settings, see Print Settings.
Paper orientation
The meanings of the icons are as follows:
Icon |
Meaning |
|---|---|
|
Place or load paper printed side face up. |
|
Place or load paper printed side face down. |
Print side |
Trays 1–4 |
Bypass tray |
|---|---|---|
One-sided |
|
|
Two-sided |
|
|
To print on letterhead paper when [Letterhead Setting] is set to [Auto Detect], you must specify [Letterhead] for the paper type in the printer driver's settings.
If a print job is changed partway through printing from one-sided to two-sided printing, one-sided output after the first copy may be printed facing a different direction. To ensure all paper is output facing the same direction, specify different input trays for one-sided and two-sided printing. Note also that two-sided printing must be disabled for the tray specified for one-sided printing.
For details about how to make two-sided prints, see Printing on Both Sides of a Page (Duplex Printing).
