Previous
Specify the width of the right margin.
Format
rightspace=distance
Printable area
Right margin (rightspace)
Value and behavior
Specify the distance from the right edge of the printable area to the area where printing ends on paper within the range of ±30 cm using an integer or decimal with its unit appended at the end. Note that there may be some discrepancy in the actual printing.
The distance can be specified in mm, inch (1 inch = approximately 25.4 mm), pt (points) or dot (number of dots) units, unless the specified value exceeds the above-mentioned range. For example, if you want to set the right margin 25 mm from the right edge of the printable area, enter the printing option as follows:
rightspace=25 mm
When no unit is appended at the end of the value, the machine calculates the area assuming the unit of the specified value is "cm".
Explanation
When this printing option is specified, the actual margin is calculated by adding this value and the value specified for "A. Right Margin" on the RTIFF Menu.
If you specify "rightspace" and Centering is enabled, the image is positioned in the center of the area derived by subtracting the specified dimension from the paper width. The left side of the images may be trimmed if the print range does not fit on the paper.
