Skip header
 

Scanning Multiple Pages of Originals as One File

This section explains the procedure for sending multiple originals as a multi-page file or storing them as a single stored file.

Important

  • To send multiple originals as a multi-page file, in [File Type], select a multi-page file type. For details about file types, see File Type.

1Press [Send Settings].

Operation panel screen illustration

2Press [Down arrow key] three times, and then press [Batch] or [SADF].

To scan originals using the exposure glass, select [Batch]. To scan originals using the ADF, select [SADF]. For detail about [Batch] and [SADF], see Batch, SADF.

3Press [OK].

4Place originals.

5Make settings for sending or storing.

6Press the [Start] key to scan originals.

If [Batch] is selected, place additional originals, and then press the [Start] key.

If [SADF] is selected, scanning starts automatically when you place additional originals. Place subsequent originals after the originals have been scanned.

Repeat this step until all originals are scanned.

7After all originals are scanned, press the [Sharp] key.

Storing or transmission starts.

Note

  • If Batch is selected, originals can be scanned using the ADF.

  • When scanning originals using the exposure glass, depending on the settings for [Wait Time for Next Orig.: Exposure Glass] in [Send Settings] under [Scanner Features], the machine can wait for additional originals even if [Batch] is not selected in [Send Settings]. For details about [Wait Time for Next Orig.: Exposure Glass], see Scan Settings.

  • If, under [Scanner Features], [Set Wait Time] is set for [Wait Time for Next Orig.: Exposure Glass] or [Wait Time for Next Original(s): SADF], place additional originals within the specified time. When the countdown ends, transmission or storage starts automatically. To start transmission or storage before the countdown is completed, press the Sharp key. Countdown is canceled if Scan Settings or other settings are changed in the meantime. Place additional originals, and then press the [Start] key. The machine scans the originals and the countdown is resumed. For details about [Wait Time for Next Orig.: Exposure Glass] and [Wait Time for Next Original(s): SADF], see Scan Settings.

  • If [SADF] is selected, scanning from the exposure glass is enabled after scanning from the ADF. If this happens, you must press the [Start] key to start scanning.