Status Messages

“Calibrating...”

The printer is calibrating the color. Wait a while.

“Hex Dump Mode”

In Hex Dump mode, the printer receives data in hexadecimal format. Press [Job Reset] to cancel Hex Dump mode.

“Initializing Unit...”

The printer is initializing. Wait a while.

“Job suspended.”

Printing was temporarily suspended because [Job Operation] or the [Suspended] key was pressed.

“Loading Toner...”

The printer is loading the toner. Wait a while.

“Offline”

The printer is offline.

“Please wait.”

This message might appear for a second or two while the printer is preparing, performing initial adjustments, or adding toner. Wait a while.

“Printing...”

The printer is printing. Wait a while.

“Ready”

This is the default ready message. The printer is ready for use. No action is required.

“Resetting job...”

The printer is resetting the print job. Wait until “Ready” appears on the display panel.

“Setting change...”

The printer is changing settings. You cannot use the control panel while this message is displayed. Wait a while.

“Suspended job exists.”

Printing was temporarily stopped by SmartDeviceMonitor for Client.

You can resume printing via [My Job List] in SmartDeviceMonitor for Client, or via the Web Image Monitor. To resume printing via Web Image Monitor, ask your system administrator first.

“Updating certif...”

The @Remote certificate is being updated. Wait a while.

“Waitg. for prt.data”

The printer is waiting for the next data to print. Wait a while.