Skip header
 

Top Page > Operating Instructions > Setting Up the Printer > Connecting the Printer > Connecting to the Wireless LAN Interface > Setup procedure

Setup procedure

This section describes how to setup wireless LAN interface.

To configure the wireless LAN settings: open [System Settings], [Interface Settings], select [Wireless LAN], and then use the following procedure.

Illustration of wireless LAN setup procedure

Note

  • Select [802.11 Ad-hoc Mode] when communicating with Windows XP as a wireless LAN client using the Windows XP standard driver or utilities, or when not using the infrastructure mode.

  • When [802.11 Ad-hoc Mode] is selected in Communication Mode, select the channel for [Ad-hoc Channel]. Set a channel that matches the type of wireless LAN being used. For details about setting the Ad-hoc Channel, see Wireless LAN Configuration.

  • For details about security type settings, see Security Guide.

  • For details about how to specify wireless LAN settings from the control panel on the printer, see Wireless LAN Configuration.

PreviousNext