Skip header
Help
 

Preparing for Printing > Connecting to a Telephone Line (SG 3110SFNw only)

Connecting to a Telephone Line (SG 3110SFNw only)

You can connect the machine to the public switched telephone network (PSTN) directly or through a private branch exchange (PBX).

Also, you can connect an external telephone to use the same telephone line for voice calls.

region-b(mainly North America)

CAUTION

  • To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord.

region-b(mainly North America)

ATTENTION

  • Pour réduire le risque d'incendie, utiliser uniquement des conducteurs de télécommunications 26 AWG ou de section supérieure.

Important

  • Make sure the connector is the correct type before you start.

  • region-b(mainly North America): By law in the United States, you must program your phone number identification (your fax number) into your machine before you can connect to the public phone system.

1Open the ADF cover.

Machine illustration

2Remove the cable cover.

Machine illustration

3Connect a telephone line cord to LINE.

Machine illustration

4If using an external telephone, connect the telephone to TEL.

Machine illustration

5Pass the telephone line cord through the opening in the cable cover.

Machine illustration

6Attach the cable cover in place.

Machine illustration

7Close the ADF cover, pressing it down firmly until it clicks.

Note

  • After connecting the machine to the telephone line, configure the telephone network settings and fax reception mode.

  • If your telephone has functions that are not compatible with this machine, those functions will not be usable.

  • Confirm that you have registered user fax number and user name during Initial Setup. You can check the registered information in [Program Fax Information] under [Fax Features].

Reference