Skip header
 

Loading Paper into the Interposer

Important

  • Load paper with its printed side up (the front side). If you are using the Booklet function with Booklet Finisher SR4070, load paper with its printed side down.

  • Load paper in the interposer in the same orientation as paper in the paper tray.

  • The staple or punching location will be on the left side of the paper, when you are facing the machine.

  • Do not place anything on top of or leave documents on the sensor. This may lead to the paper size not being correctly scanned or paper jams.

  • When using the Z-fold function, the paper in the interposer must be of the same size as the prints after they have been folded. If the paper in the interposer is larger than the Z-folded sheets, a misfeed might occur.

  • Do not use paper that has already been printed onto by this machine.

1Load paper orderly.

Do not stack paper over the limit mark.

Interposer illustration

  1. Limit mark

2Adjust the side fence to the paper size.

Interposer illustration

Note

  • To set the paper in the interposer, align the orientation of originals in the ADF as shown below.

    Interposer

    ADF

    Illustration of interposer

    Illustration of ADF

    Illustration of interposer

    Illustration of ADF