Protocol
Use the “set” command to allow or prevent remote access for each protocol.
msh> set protocol {up | down}
Protocol |
|
|---|---|
tcpip smb lpr ftp diprint web snmp ipp http |
“up” means active and “down” means inactive. |
If you prohibit remote access via TCP/IP and then log out, you cannot use remote access. If you did this by mistake, you can use the control panel to allow access by TCP/IP.
When you prevent access via TCP/IP, you are also prevented from using lpr, ftp, diprint, web, snmp, ipp, and http.
Display
The following command displays current tcpip, and smb settings.
msh> set protocol
