Skip header
 

Network Setting Parameters

This section describes the network setting parameters.

Ethernet

  • MAC Address

    Displays the machine's MAC address.

  • Ethernet Speed

    Displays the current Ethernet speed setting.

    • 100Mbps Full Duplex

    • 100Mbps Half Duplex

    • 10Mbps Full Duplex

    • 10Mbps Half Duplex

    • Ethernet Unavailable

      Appears when a network cable is not connected.

  • Set Ethernet Speed

    Specifies the speed for Ethernet communication. Select a speed that matches your network environment.

    For most networks, the default setting is the optimum setting.

    Default: [Auto Select]

    • Auto Select

    • 100Mbps Full Duplex

    • 100Mbps Half Duplex

    • 10Mbps Full Duplex

    • 10Mbps Half Duplex

IPv4 Configuration

  • DHCP

    Sets the machine to receive its IPv4 address, subnet mask, and default gateway address automatically from a DHCP server.

    Default: [Active]

    • Active

    • Inactive

  • IP Address

    Specifies the machine's IPv4 address when DHCP is not used.

    Use this menu to check the current IP address when DHCP is used.

    Default: XXX.XXX.XXX.XXX

    The numbers represented by "X" vary according to your network environment.

  • Subnet Mask

    Specifies the machine's subnet mask when DHCP is not used.

    Use this menu to check the current subnet mask when DHCP is used.

    Default: XXX.XXX.XXX.XXX

    The numbers represented by "X" vary according to your network environment.

  • Gateway Address

    Specifies the machine's default gateway address when DHCP is not used.

    Use this menu to check the current default gateway address when DHCP is used.

    Default: XXX.XXX.XXX.XXX

    The numbers represented by "X" vary according to your network environment.

  • IP Address Method

    Displays the IP address acquisition method.

    • DHCP

    • Auto IP

    • Manual Config.

    • Default IP

IPv6 Configuration

  • IPv6

    Select whether to enable or disable IPv6.

    Default: [Active]

    • Active

    • Inactive

  • DHCP

    Sets the machine to receive its IPv6 address from a DHCP server.

    Default: [Inactive]

    • Active

    • Inactive

  • IP Address (DHCP)

    Displays the IPv6 address obtained from a DHCP server.

  • Manual Config. Address

    • Manual Config. Address

      Specifies the machine's IPv6 address when DHCP is not used. Can contain up to 39 characters.

      For details about entering characters, see Entering Characters.

    • Prefix Length

      Specifies the prefix length, using a value between 0 and 128.

    • Gateway Address

      Specifies the IPv6 address of the default gateway. Can contain up to 39 characters.

      For details about entering characters, see Entering Characters.

  • Stateless Address

    Displays the IPv6 stateless addresses obtained from a Router Advertisement.

    • Stateless Address 1

    • Stateless Address 2

    • Stateless Address 3

    • Stateless Address 4

  • Link-local Address

    Displays the IPv6 link local address.

Note

  • Contact your network administrator for information about the network configuration.