Skip header
 

Entering Characters

This section describes how to enter characters using the control panel when configuring the machine's settings.

Use the keys as follows to enter characters.

To enter a digit

Press a number key.

To delete a character

Press the [Left arrow key] key.

To enter a fax number

  • To enter a number

    Use the number keys.

  • To enter characters other than digits

    "Asterisk": Press [Asterisk].

    "Sharp": Press [Sharp].

    "plus": Press [Asterisk].

    Pause: Press the [Pause/Redial] key. "P" appears on the screen.

    Space: Press the [Right arrow key] key.

To enter a name

Letters, numbers, and symbols can be entered using the number keys.

To enter two characters that use the same number key successively, wait briefly after entering the first character.

Illustration of available characters

Note

  • Characters you can enter depend on the setting you are configuring.

  • If the number you entered is too large or too small for the setting, it will not be accepted. If you press the [OK] key, the machine will increase or decrease the number to the minimum or maximum value for the setting.