Maintenance Menu Parameters

Adjust the registration of each tray if necessary. You can adjust the registration value between -1.5 and +1.5 mm in increments of 0.1 mm.

[Horiz.: Tray 2] and [Vert.: Tray 2] appear only when the optional paper feed unit is installed.

Default: 0 for all parameters

• Horiz.: Tray 1

  Select this to adjust the tray 1 registration horizontally.

• Vert.: Tray 1

  Select this to adjust the tray 1 registration vertically.

• Horiz.: Tray 2

  Select this to adjust the tray 2 registration horizontally.

• Vert.: Tray 2

  Select this to adjust the tray 2 registration vertically.

• Horiz.: Bypass

  Select this to adjust the bypass tray registration horizontally.

• Vert.: Bypass

  Select this to adjust the bypass tray registration vertically.

• Horz: Dup: Back

  Select this to adjust the duplex back side registration horizontally.

• Vert: Dup: Back

  Select this to adjust the duplex back side registration vertically.

If the machine is used in a room where humidity level is low, black lines of a few millimeters thick may appear on printouts with 75-millimeter spaces in between. Selecting [On] for this setting may prevent these lines from appearing (wait for about one day until this setting becomes effective).

Note that when this setting is enabled, the machine automatically performs self-maintenance in every 10 minutes.

Default: [Off]

• Off

• On