When “Misfd: BypssTray” Appears
“Misfd: BypssTray” appears when a paper jam has occurred in the bypass tray.
Use the following procedure to remove paper that has become jammed after being fed in from the bypass tray.
If paper is jammed in the bypass tray input area, remove the jammed paper carefully.
Close the bypass tray.
Push the side button to open the front cover, and then carefully lower it.
Carefully pull out the print cartridge horizontally, holding its center.
Do not shake the removed print cartridge. Doing so can cause remaining toner to leak.
Place the print cartridge on paper or similar material to avoid dirtying your workspace.
Lifting the guide plate, remove the jammed paper carefully.
Slide the print cartridge in horizontally. When the cartridge can go no further, raise it slightly and push it fully in. Then push down on the cartridge until it clicks into place.
Using both hands, carefully push up the front cover until it closes.
When closing the front cover, push the upper side of the cover firmly. After closing the cover, check that the error is cleared.
