6 Online Paramet's

1

Auto Online

You can specify whether to set Auto Online mode On or Off when the power is turned on or the specified setting is cancelled.

Default: [ON]

2

Print Size

You can specify the default paper size that is selected when you press the [Online] key. Turning the main switch off and on enables the set value.

Default: [Auto]

3

Prt.Size Priority

You can select the paper size specified in the printer driver or the paper size specified from the control panel.

Default: [Machine Size]

4

List/Test Print

Allows you to print the system controller's configuration data.

5

DHCP

Specify On or Off for the DHCP settings. If you specify On, the machine obtains its IP address automatically allocated by DHCP. If you specify Off, you must manually specify a static IP address.

Default: [ON]

6

IP Address

If you specify Off for the DHCP settings, you must specify a static IP address for the machine.

Default: [11.22.33.44]

7

Subnet Mask

If you specify Off for the DHCP settings, you must specify a subnet mask for the machine.

Default: [0.0.0.0]

8

Gateway Address

If you specify Off for the DHCP settings, you must specify a gateway address for the machine.

(A gateway is a connection or interchange point between two networks.)

Default: [0.0.0.0]

9

Ethernet Speed

Allows you to specify a network access speed.

Default: [Auto]

10

I/O Timeout

Allows you to specify how many seconds the machine waits before it cancels a registered print job.

Note that if job data from other ports often arrives while earlier print jobs are in progress, specifying a longer timeout period will prevent the machine from canceling the earlier jobs.

Default: [15Sec]

11

I/O Buffer

Allows you to specify I/O buffer sizes. Unless otherwise indicated, do not change this setting.

Default: [128KB]

12

Menu Reset

Allows you to reset changed settings to their factory-set default values.

Note that the following settings do not change:

• DHCP

• IP Address

• Subnet Mask

• Gateway Address

• Ethernet Speed