Zoom
Use this function to fine-tune the reproduction ratio in 1% increments.
Specify the reproduction ratio with the [
] or [
] key (Zoom keys).
Alternatively, you can first select a preset ratio close to the ratio you want to use, then fine-tune it with the [] or [] key.
Set your original.
Make sure the [Master Making] mode select key is lit.
If it is not lit, press the [Master Making] mode select key.
Enter the number of prints you want using the number keys.
Press the [Start] key.
Printing starts automatically after the trial print.
You can select from a range of 50–200%.
If you want to check the image before printing, press the [Auto Cycle] key before pressing the [Start] key, in order to disable Auto Cycle mode. See When Auto Cycle Mode Is Off
.
