Previous
This section explains the procedure for stamping originals that are scanned from the ADF. The stamp indicates the originals have been scanned.
When scanning a document using ADF, the machine can stamp a circle mark at the bottom of the original. When scanning a two-sided document, the document is marked at the bottom of the front page and top of the rear page.
This function is useful when you want to distinguish scanned originals.
The stamp position may differ depending on the model you are using.
The stamp position may be either in the center of the rear edge in relation to the scan direction (the circle in the center of the illustration) or near the top of the rear edge (the circle on the upper right corner).
Press [Original Feed Type].
Press [Stamp].
Press [OK].
The [Stamp] function is available only if the ADF is installed on the machine. Note that in some countries, the ADF is an optional component and must be purchased separately.
Last pages are stamped even if you selected not to scan the last page.
Stamping may continue if scanning is interrupted, depending on the cause of interruption.
When the stamp starts getting lighter, replace the cartridge. For details, see "Replacing the Stamp Cartridge", Maintenance and Specifications.
