Previous
The paper size setting is changed in the same way for every paper tray.
In the following example procedure, the paper size setting for tray 2 is changed.
Check the paper edges are aligned at the right side.
Slide the side fences until they are aligned with the sides of the paper, and then re-lock the side fences. If there is space between the side fences and the paper, it may cause the image to be misaligned or thin paper may wrinkle.
If a paper tray is pushed vigorously when putting it back into place, the position of the tray's side fences may slip out of place.
When loading a low number of sheets, be sure not to squeeze the side fences in too tightly. If the side fences are squeezed too tightly against the paper, the edges may crease, thin paper may wrinkle, or the paper may be misfed.
Check that paper in the paper tray is not being used, and then pull the tray carefully out until it stops.
Remove paper if loaded.
Release the lock on the side fences.
While pressing down the release lever, slide the side fences outward.
Slide the end fence outward.
Pinch the release levers of the end fence.
Slide the end fence outward.
Square the paper and load it print side up.
Do not stack paper over the limit mark.
Align the back and side fences gently against the paper you loaded.
Re-lock the side fences.
Carefully slide the paper tray fully in.
Check the paper size on the display.
You can load envelopes into the paper trays. When loading envelopes, place them in the correct orientation. For details, see Envelopes
.
