Previous
Every paper tray is loaded in the same way.
In the following example procedure, paper is loaded into tray 2.
If a paper tray is pushed vigorously when putting it back into place, the position of the tray's side fences may slip out of place.
Check the paper edges are aligned at the right side.
When loading a low number of sheets, be sure not to squeeze the side fences in too tightly. If the side fences are squeezed too tightly against the paper, the edges may crease, thin paper may wrinkle, or the paper may be misfed.
Carefully pull out the paper tray until it stops.
Square the paper and load it print side up.
Do not stack paper over the limit mark.
Carefully push the paper tray fully in.
Various sizes of paper can be loaded in the paper trays by adjusting the positions of side fences and end fence. For details, see Changing the Paper Size in the Paper Trays
.You can load envelopes in the paper trays. Envelopes must be loaded in a specific orientation. For details, see Envelopes
.
