Skip header
 

Printing text and serial numbers

Illustration of Stamp Text

Before using this function, select [On] under [Change Job Serial No. for First Job] in User Tools. For details, see Stamp Text.

Important

  • You cannot use the bypass tray with this function.

1Press [Edit / Stamp].

Operation panel screen illustration

2Press [Stamp].

3Press [Stamp Text].

4Press [Change Text].

5Enter stamp text, and then press [OK].

6Press [Change Start No.].

7Enter a number from which to start numbering, and then press [Sharp].

8Press [OK].

9Press [Change].

10Select the stamp position, and then press [OK].

Operation panel screen illustration

11Press [OK] twice.

Note

  • You can enter up to 64 characters by combining texts and numbers.

  • The number is displayed in nine digits. If you enter "1", the number is printed as "000000001".

  • When Auto Clear is done, the [Reset] key is pressed, or the power is turned off, the text is cleared and the next number in the sequence is displayed.

  • This function cannot be used for the Job Preset or Interrupt Copy function. Also, this function cannot be used to print stored documents.

  • If this function is used with the Combine function, a print image may differ according to the [Page Numbering in Combine] settings under [Page Numbering]. For details, see Page Numbering.

  • For details about Stamp Text, see Stamp Text.

PreviousNext