Specifying the scanning size according to the size of the original

This section describes how to specify the scanning size according to the size of the current original.

Press the [Reduce/Enlarge] key or [Scn Size].
Press the [][] keys to select the size of the original, and then press the [OK] key.
If you selected anything other than [Custom Size], you do not need to perform the remaining steps of the procedure.
Press the [][] keys to select [mm] or [inch], and then press the [OK] key.
Enter the width using the number keys, and then press the [OK] key.
To enter a decimal point, press [].
Enter the length using the number keys, and then press the [OK] key.
To enter a decimal point, press [].

You can press the [Escape] key to exit to the previous level of the menu tree.
You can change the machine's default [Scan Size] setting to always scan originals with a specific scanning size.
Temporary job settings are cleared in the following cases:
- When no input is received for the period of time specified in [System Auto Reset Timer] while the initial screen is displayed.
- When the [Clear/Stop] key is pressed while the initial screen is displayed.
- When the machine's mode is changed.
- When the power is turned off.
- When the machine's default for the same setting is changed.