Making Enlarged or Reduced Copies

This section describes how to specify the reduction or enlargement ratio for the current job.

Scaling

There are two ways to set the scaling ratio: using a preset ratio or manually specifying a customized ratio.

Preset ratio
50%, 71%, 82%, 93%, 122%, 141%, 200%, 400%
50%, 65%, 78%, 93%, 129%, 155%, 200%, 400%
Custom ratio
25% to 400% in 1% increments.

Use this procedure to specify the reduction or enlargement ratio for the current job.

Press the [Reduce/Enlarge] key.
Press [Reduce] or [Enlarge], press the [][][][] keys to select the desired ratio, and then press the [OK] key.
If [Zoom] has been selected, specify the desired ratio using the number keys, and then press the [OK] key.

You can press the [Escape] key to exit to the previous level of the menu tree.
You can change the machine's default [Reduce/Enlarge] setting to always make photocopies in the specified ratio.
Temporary job settings are cleared in the following cases:
- When no input is received for the period of time specified in [System Auto Reset Timer] while the initial screen is displayed.
- When the [Clear/Stop] key is pressed while the initial screen is displayed.
- When the machine's mode is changed.
- When the power is turned off.
- When the machine's default for the same setting is changed.