Skip header
 

Top Page > Getting Started > Installing Option > Installing the Paper Feed Unit (Tray 2)

Installing the Paper Feed Unit (Tray 2)

WARNING

  • Touching the prongs of the power cable's plug with anything metallic constitutes a fire and electric shock hazard.

WARNING

  • It is dangerous to handle the power cord plug with wet hands. Doing so could result in electric shock.

CAUTION

  • Before installing or removing options, always disconnect the power cord plugs from the wall outlet and allow time for the main unit to fully cool. Failing to take these precautions could result in burns.

CAUTION

  • The machine weighs approximately 30.0 kg (66.2 lb.). When moving the machine, use the inset grips on both sides, and lift slowly in pairs. The machine will break or cause injury if dropped.

CAUTION

  • Lifting the paper feed unit carelessly or dropping may cause injury.

CAUTION

  • Before moving the machine, unplug the power cord from the wall outlet. If the cord is unplugged abruptly, it could become damaged. Damaged plugs or cords can cause an electrical or fire hazard.

Important

  • The machine should always be lifted by two people.

  • Tray 1 is required to print using the optional paper feed unit. Without Tray 1, paper jams will occur.

  • Do not grip the tray areas when moving the machine.

1Check that the package contains paper feed unit.

Machine illustration

2Turn off the power, and then unplug the machine's power cord from the wall outlet.

3Remove the adhesive tape from the optional paper feed unit.

Machine illustration

4Lift using the inset grips on both sides of the machine.

Machine illustration

5There are three upright pins on the optional paper feed unit. Align them with the holes on the underside of the machine, and then carefully lower the machine onto them.

Machine illustration

6After installing the option, print the configuration page to confirm the installation.

If it is installed properly, “Tray 2” will appear under “Paper Input” on the configuration page.

Note

  • After installing the optional paper feed unit, select tray 2 in the printer driver. For details, see the printer driver Help.

  • If the optional paper feed unit is not installed properly, reinstall it following this procedure. If you cannot install it properly even after attempting reinstallation, contact your sales or service representative.

Reference