Attaching Paper Feed Unit

Touching the prongs of the power cable's plug with anything metallic constitutes a fire and electric shock hazard.

It is dangerous to handle the power cord plug with wet hands. Doing so could result in electric shock.

Before installing or removing options, always disconnect the power cord plugs from the wall outlet and allow time for the main unit to fully cool. Failing to take these precautions could result in burns.

The printer weighs approximately 23.8 kg (52.5 lb.). When moving the printer, use the inset grips on both sides, and lift slowly in pairs. The printer will break or cause injury if dropped.
Lifting the paper feed unit carelessly or dropping may cause injury.
Before moving the printer, unplug the power cord from the wall outlet. If the cord is unplugged abruptly, it could become damaged. Damaged plugs or cords can cause an electrical or fire hazard.

Tray 1 is required to print using the optional paper feed unit. Without Tray 1, paper jams will occur.
The printer should always be lifted by two people.
Do not grip on the tray area when lifting the printer.

Check the package contains Paper Feed Unit.
Turn off the printer's power switch, and then unplug the printer's power cord from the wall outlet.
Remove the adhesive tape from the optional paper feed unit.
Lift the printer using the inset grips on both sides of the printer.
There are three upright pins on the optional paper feed unit. Align them with the holes on the underside of the printer, and then carefully lower the printer.
After installing the option, print the configuration page to confirm the installation.

When moving the printer, remove the optional paper feed unit.
Before using the optional paper feed unit, you can make settings in the printer driver.
If the new device is listed in the column of configuration options, then it has been properly installed.
If the optional paper feed unit is not installed properly, reinstall it following this procedure. If you cannot install it properly even after attempting reinstallation, contact your sales or service representative.