Skip header
 

Setting the Ethernet Speed

You can set the speed that the printer will use for Ethernet communication. For normal usage, the default setting [Auto Select] is suitable and does not need to be changed. This setting allows two connected interfaces to automatically determine the optimum speed that they will communicate at.

Router/HUB

Printer

[10Mbps Half D.]

[10Mbps Full D.]

[100Mbps Half D.]

[100Mbps Full D.]

[Auto Select]

10Mbps Half Duplex

OK

minus

minus

minus

OK

10Mbps Full Duplex

minus

OK

minus

minus

minus

100Mbps Half Duplex

minus

minus

OK

minus

OK

100Mbps Full Duplex

minus

minus

minus

OK

minus

auto-negotiation (auto selection)

OK

minus

OK

minus

OK

Important

  • Connection cannot be established if the selected Ethernet speed does not match your network's transmission speed.

  • The use of this feature is recommended. To use it, select [Auto Select].

1Press the [Menu] key.

Menu key illustration

2Press the [Up arrow key] or [Down arrow key] key to display [Host Interface], and then press the [OK] key.

Menu:               
Host Interface      

3Press the [Up arrow key] or [Down arrow key] key to display [Network Setting], and then press the [OK] key.

Host Interface:     
Network Setting     

4Press the [Up arrow key] or [Down arrow key] key to display [Ethernet Speed], and then press the [OK] key.

Network Setting:    
Ethernet Speed      

5Press the [Up arrow key] or [Down arrow key] key to select the Ethernet speed, and then press the [OK] key.

6Press the [Menu] key.

7Print a configuration page to confirm the settings made.

Reference

  • For details about printing the configuration page using control panel, see Test Printing.