Handling the Print Cartridge

This section describes how to replace and store the print cartridge.

If metal objects, or water or other fluids fall inside this machine, you must turn off its power immediately. After turning off the power, be sure to disconnect the power cord plug from the wall outlet. Then contact your service representative and report the problem. Do not use the machine. Doing so could result in fire or electric shock.

Do not incinerate toner (new or used) or toner containers. Doing so risks burns. Toner will ignite on contact with naked flame.

Do not store toner (new or used) or toner containers anywhere near naked flames. Doing so risks fire and burns. Toner will ignite on contact with naked flame.

Do not incinerate spilled toner or used toner. Toner dust might ignite when exposed to an open flame.

Do not crush or squeeze toner containers. Doing so can cause toner spillage, possibly resulting in dirtying of skin, clothing, and floor, and accidental ingestion.

Store toner (new or used), toner containers, and components that have been in contact with toner out of reach of children.

If toner or used toner is inhaled, gargle with plenty of water and move into a fresh air environment. Consult a doctor if necessary.

If toner or used toner gets into your eyes, flush immediately with large amounts of water. Consult a doctor if necessary.

If toner or used toner is swallowed, dilute by drinking a large amount of water. Consult a doctor if necessary.

When removing jammed paper or replacing toner, avoid getting toner (new or used) on your clothing. If toner comes into contact with your clothing, wash the stained area with cold water. Hot water will set the toner into the fabric and make removing the stain impossible.

When removing jammed paper or replacing toner, avoid getting toner (new or used) on your skin. If toner comes into contact with your skin, wash the affected area thoroughly with soap and water.

The print cartridge might need to be replaced even if there is toner remaining in it. This is due to depletion or wear of other components.
Do not shake or shock the print cartridge.
When removing print cartridge, be careful not to drop it.
Fault may occur if you use the print cartridge other than the recommended type.
When replacing the print cartridge, do not turn off the operation switch. If you do, settings will be lost.
Store the print cartridge where it will not be exposed to direct sunlight, temperatures above 35 °C (95 °F), or high humidity.
Store the print cartridge on a flat surface.

If “Replacement of Print Cartridge is now necessary.” appears, replace the print cartridge.
If “Replacement of Print Cartridge will soon be necessary.” appears, have a replacement print cartridge at hand.
You can check the name of the required print cartridge and the replacement procedure using the “Replace Print Cartridge” screen.
Press [System Status] to check contact number where you can order supplies. See “Checking Machine Status and Settings”, Troubleshooting.