Skip header
Help
 

Placing Originals in the Auto Document Feeder

Place originals in the ADF.

Important

  • When inserting originals in the ADF, push them in once and without force.

  • After turning on the power, do not place originals in the ADF until the “Ready” message appears.

Be sure not to place originals or other objects on the top cover. Doing so may cause a malfunction.

Settings should be made in the following situations:

When the number of originals placed in the ADF exceeds the limit:

See “Batch Mode”.

When placing originals one by one:

See “SADF Mode”.

1Open the cover of the ADF.

ADF illustration

2Place the aligned original face up into the ADF, and then adjust the document guides to the original size.

Do not stack originals beyond the limit mark.

The first page should be on the top.

ADF illustration numbered callout illustration

  1. Document guides

  2. Limit mark

Note

  • The machine cannot detect the size of the original automatically. Specify the original size. However, if [Use Paper Tray Settg] is specified in Original Settings, you do not have to specify the size of the original. For details about how to specify the original size, see “Specifying Original Sizes”. For details about [Use Paper Tray Settg], see “Using paper tray settings”.

  • Straighten curls in the originals before placing them in the ADF.

  • To prevent multiple sheets from being fed at once, fan the original before placing it in the ADF.

  • Set the original squarely.