Skip header
ManualsContentsPreviousNextHelp

Quality Maintenance

Image Density Adjustment

Adjusting the print image density can prevent faint spots or smears appearing on printed pages. You can specify a density value between Minus6 and Plus3.

Only change this setting from its default value if necessary. For details about adjusting the print image density, see "Adjusting the Image Density", Hardware Guide.

Registration

You can adjust the starting position of the printing page. For details, see "Adjusting Printing Position", Hardware Guide.

  • Print Test Sheet

    You can print the registration test sheet.

    Only the installed trays appear on the display panel.

    • Tray 1

    • Tray 2

    • Tray 3

    • Bypass Tray

    • Duplex Unit

  • Adjustment

    You can select the start position for printing on a page.

    Only the installed trays appear on the display panel.

    • Horizontal: Tray 1

    • Horizontal: Tray 2

    • Horizontal: Tray 3

    • Horizontal: Bypass Tray

    • Horizontal: Back Side

    • Vertical: Std. Ppr Tray

    • Vertical: Opt. Ppr Tray

    • Vertical: Bypass Tray

    • Vertical: Back Side

Curl Prevention

You can control the fuser temperature to prevent paper from curling. Use this mode only when paper misfeed occurs frequently during duplex printing.

Default: [Off]

  • On

  • Off