Skip header
 

Installing the Wireless LAN Interface Board

Important

  • Before beginning work, ground yourself by touching something metal to discharge any static electricity. Static electricity can damage the unit.

  • Do not subject the unit to physical shocks.

1Check the contents of the package.

Wireless LAN interface board illustration

2Turn off the power, and then unplug the power cord.

3Remove the two screws and remove the cover of the slot in which the Wireless LAN interface board is installed.

Rear side of the printer illustration

4Fully insert the Wireless LAN interface board.

Rear side of the printer illustration

5Tighten the two screws to secure the interface board.

Check the Wireless LAN interface board is connected firmly to the interface board slot.

Rear side of the printer illustration

Note

  • Confirm that the interface board was correctly installed by printing the configuration page. If it is correctly installed, "Wireless LAN" will appear for "Device Connection" on the configuration page.

  • If the board was not installed properly, repeat the procedure from step 3. If it cannot be installed correctly even after reattempting installation, contact your sales or service representative.

  • For details about printing the configuration page, see Test Printing.

  • Before using the Wireless LAN interface board, you must configure settings from the printer control panel. For details, see Wireless LAN Configuration.