Skip header
 

Specifying the Classification Code for a Print Job

When printing in an environment where classification codes are required, a classification code must be specified for each print job.

Important

  • The PostScript 3 printer driver does not support the classification codes and it cannot be used to print under environment which the classification codes are required.

For the PCL 6 printer driver:

1Open the printer properties dialog box after creating a document in an application.

2Click the [Detailed Settings] tab.

3In the [Menu:] box, click the [Job Setup] icon.

4Enter the classification code in the [Classification code:] box, and then click [OK].

This code identifies the user. The classification code can contain up to 32 alphanumeric (a-z, A-Z, 0-9, "-") characters.

5Make any other necessary print settings, and then click [OK].

6A confirmation message appears. Read it, and then click [OK].

7Execute the print command.

8The print job is sent to the printer.

For the PCL 5e printer driver:

1Open the printer properties dialog box after creating a document in an application.

2Click the [Valid Access] tab.

3Enter the classification code in the [Classification Code:] box.

This code identifies the user. The classification code can contain up to 32 alphanumeric (a-z, A-Z, 0-9, "-") characters.

4Make any other necessary print settings, and then click [OK].

5A confirmation message appears. Read it, and then click [OK].

6Execute the print command.

7The print job is sent to the printer.

Note

  • The specified classification code is stored in the printer driver.

  • To switch between different classification codes, install the printer driver under different names, and specify different classification code for each driver.

  • For details about how to view the log collected using Classification Code, see the manual for the external log collection system.