Skip header
 

Programming Initial Set Up of a Special Sender

This section describes how to program Initial Set Up of a Special Sender.

Program the “Initial Set Up” of a Special Sender. You can also specify the Bypass Tray Paper Size.

1Press [Facsimile Features].

2Press [Reception Settings].

3Press [Program Special Sender].

4Press [Initial Set Up].

Operation panel screen illustration

5Select the function you want to program.

Operation panel screen illustration

6To program Authorized Reception and Special Reception Function, press [Authorized Reception] or [Special Reception Function].

7Press [On] or [Off], and then press [OK].

The illustration shows the “Authorized Reception” display as an example.

Operation panel screen illustration

8To program Bypass Tray Paper Size, press [Bypass Tray Paper Size].

9Select the size you want to program.

You can select a size from [Auto Detect], [Regular Size], or [Custom Size].

If you select [Auto Detect], proceed to step 14.

If you select [Regular Size], proceed to step 10.

If you select [Custom Size], proceed to step 11.

10Select the size you want to program from the sizes shown.

Operation panel screen illustration

After selecting the size, proceed to step 14.

11Make sure that [Vertical] is selected.

12Enter the vertical size of the paper using the number keys, and then press the [Sharp] key.

Operation panel screen illustration

Specify a vertical size from 90 mm (3.6 inches) to 305 mm (12.0 inches).

Each time you press [mm] or [inch], the units switch between “mm” and “inch”.

If you enter a length and change the units by pressing [mm] or [inch], it is converted automatically (fractions are rounded off).

13Enter the horizontal size of the paper using the number keys, and then press the [Sharp] key.

Operation panel screen illustration

Specify a horizontal size from 148 mm (5.9 inches) to 600 mm (23.6 inches).

Each time you press [mm] or [inch], the units switch between “mm” and “inch”.

If you enter a length and change the units by pressing [mm] or [inch], it is converted automatically (fractions are rounded off).

14Press [OK].

15Press [Exit].

16Press the [User Tools/Counter] key.

Note

  • If you select [Auto Detect], the machine recognizes the paper size automatically.