Setting the Ethernet Speed

You can set the speed that the printer will use for Ethernet communications. In most cases, this should be left on the default setting, [Auto Select]. This setting allows two interfaces to automatically determine the optimum speed when they are connected.

Router/HUB	Printer
Router/HUB	[10Mbps Half Duplex]	[10Mbps Full Duplex]	[100Mbps Half Duplex]	[100Mbps Full Duplex]	[Auto Select]
10 Mbps half duplex		-	-	-
10 Mbps full duplex	-		-	-	-
100 Mbps half duplex	-	-		-
100 Mbps full duplex	-	-	-		-
auto-negotiation (auto selection)		-		-

Connection cannot be established if the selected Ethernet speed does not match your network's transmission speed.
The use of this feature is recommended. To use it, select [Auto Select].

Press the [Menu] key.
Press the [ ] or [ ] key to select [Host Interface], and then press the [OK] key.
Press the [ ] or [ ] key to select [Network], and then press the [OK] key.
Press the [ ] or [ ] key to select [Ethernet Speed], and then press the [OK] key.
Press the [ ] or [ ] key to select the Ethernet speed, and then press the [OK] key.
Press the [Menu] key to return to the initial screen.
Print a configuration page to confirm the settings.

For details about printing the configuration page, see "Test Printing".

Test Printing