Skip header
 

Top Page > Hardware Guide > Installing Options > Installing the SD Memory Card Options

Installing the SD Memory Card Options

This section explains how to install the following SD memory cards: the camera direct print card, data overwrite security unit, HDD encryption unit, NetWare card, and VM card.

CAUTION

  • Keep SD memory cards out of reach of children. If a child swallows an SD memory card, consult a doctor immediately.

Important

  • Do not subject the card to physical shocks.

  • The VM card is optional to use it, the optional 512 MB SDRAM module must be installed.

1Check the contents of the package.

SD Card illustration

2Turn off the power, and then unplug the power cord.

3Remove the cable cover.

Rear side of the printer illustration

4Remove the one screw, and then carefully remove the cover of the SD card slot.

Rear side of the printer illustration

5Carefully push in the SD card (notched corner upward and leading), until it clicks into place.

Rear side of the printer illustration

Insert the SD card in the appropriate slot as follows:

  • Upper slot: Camera direct print card, Data overwrite security unit, NetWare card

  • Lower slot: HDD encryption unit, VM card

6Reattach the cover over the SD card. Fasten the one screw to secure the cover.

Rear side of the printer illustration

7Attach the cable cover.

Rear side of the printer illustration

Note

  • Do not touch the card while the printer is in use. It may come loose, even if pushed only slightly. The slot cover must be reattached.

  • You can confirm that the SD card was installed correctly by checking the control panel menu. Depending on the SD card, certain menu items appear on the display.

    • Data overwrite security unit: Set [Auto Erase Memory Setting] under [Security Options] to [On], and then check [Memory Erase Status].

    • HDD encryption unit: Make sure [Machine Data Encryption] appears in [Security Options] is displayed. Depending on settings, [Machine Data Encryption] might not appear. For details about how to confirm this setting, consult your administrator.

  • Confirm that the camera direct print card was correctly installed by printing the configuration page. If the camera direct print card is installed properly, "PictBridge" will appear for "Attached Equipment" in "System Reference".

  • If the card is not installed properly, repeat the procedure from the beginning. If it cannot be installed correctly even after reattempting installation, contact your sales or service representative.

  • For details about printing the configuration page, see "Test Printing".

Reference