Sending over a Fax Line (Fax Destinations)

This section explains how to enter a fax number.

Use the number keys on the right side of the control panel to enter numbers.

Make sure that [Fax] is selected.
Enter the fax number using the number keys.
If you make a mistake, press the [Clear/Stop] key, and then enter again.
When adding a destination, pressing the transmission type tab switches the transmission type between fax/IP-Fax, Internet Fax, e-mail, and folder.
Press the [Start] key.
The machine starts to scan the original and stores it in memory. When scanning ends, the Communicating indicator lights and transmission starts.

To select a destination from the Address Book, see “Using the Address Book to Specify Destinations”.
You can insert pauses and tones in a fax number. For details, see “Entering a pause” or “Entering a tone”.
Press [Prg. Dest.] after entering the fax number to store the fax number in the destination list. For details about storing numbers you entered, see “Registering Entered Destinations to the Address Book”.
For the maximum number of digits that can be included in a destination, see “Maximum Values”.