ManualsContentsPreviousNext |
This section introduces the names and functions of the components of type 1 and 2.
Do not obstruct the ventilation holes by placing objects near them or leaning things against them. If the machine overheats, a fault might occur.
Front and left view
ARDF
Lower the ARDF over originals placed on the exposure glass.
If you load a stack of originals in the ARDF, the ARDF will automatically feed the originals one by one. The ARDF scans both sides of an original one side at a time.
Exposure glass
Place originals face down here.
Ventilation holes
Prevent overheating.
Main power switch
If the machine does not operate after turning on the operation switch, check if the main power switch is turned on. If it is off, turn it on. See “Turning On/Off the Power”.
Control panel
See “Control Panel”.
Internal tray 1
Copied/printed paper and fax messages are delivered here.
Front cover
Open to access the inside of the machine.
Paper trays (trays 1 2)
Load paper here.
Lower paper trays (optional)
Load paper here.
Operation switch
Press to turn the power on (the operation switch indicator lights up). To turn the power off, press again (the operation switch indicator goes off). See “Turning On/Off the Power”.
Front and right view
Ventilation holes
Prevent overheating.
Bypass tray
Use to copy or print on OHP transparencies, label paper (adhesive labels), envelopes and custom size paper.
Extender
Pull this extender out when loading sheets larger than A4 in the bypass tray.
Lower right cover
Open this cover when a paper jam occurs.
Rear and right view
Ventilation holes
Prevent overheating.