Skip header
 

Top Page > About This Machine > Adding Paper > Loading Paper > Loading Paper into Trays 1 - 4

Loading Paper into Trays 1 - 4

This section describes how to load paper into trays 1 hyphen 4.

Every paper tray is loaded in the same way.

In the following example procedure, paper is loaded in tray 2.

Important

  • Tray 1 can hold 81/2 × 11Portrait paper only. If you want to print on A4Portrait, A5Portrait, or B5 JIS (Japanese Industrial Standard)Portrait from tray 1, contact your service representative.

  • Check the paper edges are aligned at the right side.

1Carefully pull out the paper tray until it stops.

Tray 2 illustration

2Square the paper and load it print side up.

Do not stack paper over the limit mark.

Tray 2 illustration

3Carefully push the paper tray fully in.

Note

  • When loading a low number of sheets, be sure not to squeeze the side fences in too tightly. If the paper bows, it might not feed in properly.

  • If a paper tray is pushed vigorously when putting it back into place, the position of the tray's side fences may slip out of place.

  • Various sizes of paper can be loaded in trays 2 hyphen 4 by adjusting the positions of side fences and end fence. For details, see “Changing the Paper Size in Trays 2 hyphen 4”.

  • You can load envelopes in trays 2 hyphen 4. For details about how to load envelopes, see “Changing the Paper Size in Trays 2 hyphen 4”. For details about various details about and recommendations concerning envelopes, see “Envelopes”.

  • Each tray can hold up to 550 sheets.

Reference