Skip headerPro C901
ManualsContentsPreviousNextHelp

Top Page > Troubleshooting > Adding Paper, Toner, Staples, Rings and Glue > Changing the Paper Size > Changing to a Size That Is Not Automatically Detected

Changing to a Size That Is Not Automatically Detected

This section describes how to set the paper size that is not automatically detected.

When paper is loaded which cannot be detected automatically, the user must set the paper size on the control panel.

  1. Press the [Paper Setting] key.

    Paper Setting key illustration

  2. Select the tray number on the screen.

  3. Press [Paper Size] tab.

  4. Select the loaded paper size and feed direction, and then press [OK].

  5. Press the [Paper Setting] key.

Note

TopPreviousNext
Copyright (C) 2010